Stihl FS 55 Instruction Manual page 14

English
► Position the clamp (6) against the drive tube.
► Place the barrier bar (2) in position as shown.
► Line up the holes.
► Insert the screws (7) in the holes and screw
them into the barrier bar (2) as far as stop.
► Go to "Securing the Loop Handle".
5.2 Mounting the Loop Handle
without Barrier Bar
7
8
6
1
► Place the clamp (3) in the loop handle (4) and
position them both against the drive tube (5).
► Position the clamp (6) against the drive tube.
► Line up the holes.
► Fit washers (8) on the screws (7) and insert
the screws in the holes. Fit the square nuts (1)
and screw them down as far as stop.
► Go to "Securing the Loop Handle".
14
7
8
4
3
5
1
5 Mounting the Loop Handle
5.3 Securing the Loop Handle
A
9
The loop handle can be adjusted to suit the
height and reach of the operator and the applica‐
tion by changing distance (A).
Recommendation: distance (A): about 20 cm
(8 in)
► Slide the handle to the required position.
► Line up the loop handle (4).
► Tighten down the screws until the loop handle
can no longer be rotated on the drive tube. If
no barrier bar is fitted – lock the nuts if neces‐
sary.
The sleeve (9) (not fitted on all models) must be
between the loop handle and the control handle.
4
0458-233-8321-G