Table of Contents
Advertisement
ESL Intensifier
Introduction
This manual will help you become familiar with your new Flow International equipment. Information was compiled
from the most current information available at the time of publication.
Safety
A comprehensive list of safety precautions is located in your pump manual. These precautions must be reviewed
and understood by operating and maintenance personnel before installing, operating or servicing the equipment.
The high-pressure waterjet system is a powerful cutting tool and must always be treated with respect.
Warnings, cautions, and notes
Before operating the equipment, please thoroughly understand and adhere to all warnings, cautions, and notes that
appear in this manual. These are defined as follows:
Note: Highlights an operating or service procedure or condition that is essential for efficient operation and service.
Related documents
Your equipment was shipped with several manuals. Some are shipped with every system; others are specific de-
pending on the model of intensifier pump purchased. Other manuals than those listed may have been shipped
with your system if the ESL intensifier was installed as a retrofit kit.
Every system comes with the following manual:
M-127, Small High-Pressure Components
•
One of these pump and/or system manuals was shipped with the equipment:
M-287, 7X Intensifier Pump
•
M-294, 25X Intensifier Pump
•
M-331, 20XW Intensifier Pump
•
M-368, IFB DWJ 50iS
•
M-371, IFB 50iS
•
M-378, IFB DWJ 100iD
•
M-380, IFB 100iD
•
M-373, WMC2 50iS
•
M-375, WMC2 100iD
•
M-377, 30XQ Pump
•
M-384, IFB StoneCrafter
•
M-387, 30SA Intensifier Pump
•
4 | M-310
Highlights an operating or service procedure or condition
that can result in death or serious injury to personnel.
Highlights an operating or service procedure or condition that can lead
to impaired system operation or equipment damage.
WARNING
CAUTION
© Flow International Corporation
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the ESL INTENSIFIER and is the answer not in the manual?
Questions and answers
the red lights on side of sensors when pump is off only bottom two are illuminated
The bottom two red lights on the Flow ESL Intensifier sensors are illuminated when the pump is off because the system is not pressurized, and no hydraulic movement is occurring. These lights likely indicate a default or standby state when the pump is not actively generating high-pressure water.
This answer is automatically generated