Completing Installation; Specifications - Heath Zenith 6113 Manual

IMPORTANT: When sliding the control
switch from OFF to AUTO, there is a 1
minute warm up period before the control
will become fully functional.
IMPORTANT: In AUTO mode, if the sensor
turns the light off, there is an 8 second
delay before the sensor will turn the lights
on when motion is sensed.

COMPLETING INSTALLATION

1. Replace the decorative wall plate. In installations
where the motion sensor switch is combined
with other switches or outlets on an expanded
box, you will need to purchase a combination
wall plate. Various combination wall plates are
available at home centers and electrical supply
stores.
2. Slide the mode selection switch a couple times
to make sure it moves freely.
This product is to be installed indoors only.
Electrical Input ........................................................................................................................120V, 60 Hz.
LED .................................................................................................................. Up to 400 Watts Maximum
Self-Ballasted CFL ........................................................................................... Up to 400 Watts Maximum
Fluorescent Load .............................................................................................. Up to 400 Watts Maximum
Incandescent ...................................................................................Up to 500 Watts Maximum at 120VAC
Motor Load ...........................................................................................................Up to 1/8 HP Maximum
On-Time .....................................................................................................................5 Minute Fixed Time
Coverage ........................................ up to 10 ft. (3.5 m) at 110°, up to 20 ft. (6.1 m) in front of the sensor
200069-02
This switch allows you to select one of three modes
of operation: OFF, AUTO, or ON.
OFF: Lights stay off.
AUTO: Lights automatically come on when motion
is detected. The lights will turn off 5 minutes after
motion is no longer detected.
ON: Lights stay on continuously.
IMPORTANT THINGS TO REMEMBER
• The motion switch will sound a low audible click
when motion is detected.
• The switch will activate only if the motion switch
is in AUTO mode.

SPECIFICATIONS

3
MODE SELECTION SWITCH