Table of Contents
Advertisement
Commissioning
7.4 Notes on operation
7.4.2
Removable hard disks
The removable cartridges support hot-swapping in a RAID1 system.
Replacing a hard disk
CAUTION
Hard drives may only be replaced in an removable cartridge if the device status display is
off.
Note
The table and information below apply only to the delivery state of the device, that is no
changes or expansions were made.
How to remove the hard disk drive:
1. Check which hard disk the RAID controller has reported being faulty (hard disk at channel
1 or 2).
The table below shows the assignment of the removable cartridge positions in the device to
the RAID system reports:
RAID BIOS
Port 0
Port 2
Information about the recovery of the RAID system is available in the next section.
1. Set the key switch to the "OPEN" position.
2. Lift up the folding handle of the hard disk cartridge.
3. Pull the hard disk cartridge out.
38
RAID software
SATA interface
Device Port 0
SATA1
Device Port 2
SATA3
(1)
Power LED
voltage supply available
(2)
HDD activity display
Installation location
Enclosure labeling
(3) Removable
1
cartridge 1
(4) Removable
2
cartridge 2
SIMATIC Rack PC 547B
Operating Instructions, 12/2007, A5E01127519-02
Advertisement
Table of Contents
