Remote Commands - Brother MFC-210C User Manual

Remote commands

Follow the commands below to access features when you are away
from the MFC. When you call the MFC and enter your Remote
Access Code (3 digits followed by
beeps and you must enter a remote command.
Remote commands
95 Change the Fax Forwarding
or Fax Storage settings
1 OFF
2 Fax Forwarding
4 Fax Forwarding number
6 Fax Storage
96 Retrieve a fax
2 Retrieve all faxes
3 Erase faxes from the
memory
97 Check the receiving status
1 Fax
98 Change the Receive Mode
1 External TAD
2 Fax/Tel
3 Fax Only
90 Exit
), the system will give two short
Operation details
You can select Off after you have retrieved
or erased all your messages.
If you hear one long beep, the change has
been accepted. If you hear three short beeps,
you cannot change it because the conditions
have not been met (for example, registering a
Fax Forwarding number). You can register
your Fax Forwarding number by entering 4.
(See Changing your Fax Forwarding number
on page 6-6.) Once you have registered the
number, Fax Forwarding will work.
Enter the number of a remote fax machine to
receive stored fax message(s). (See page
6-6.)
If you hear one long beep, fax messages
have been erased from the memory.
You can check whether your MFC has
received any faxes. If yes, you will hear one
long beep. If no, you will hear three short
beeps.
If you hear one long beep, your change has
been accepted.
Press 90 to exit Remote Retrieval. Wait for
the long beep, then replace the handset.
REMOTE FAX OPTIONS (MFC-410CN ONLY) 6 - 5