3)
Cleaning Procedure – After EVERY Service to Avoid Clogging and
Deposit of Any Kind Inside Handpiece and Hoses.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10. After running a full bottle of warm distilled water through the S3
Replace clear solution tip on hand set with blue cleaning tip.
To perform cleaning, remove Solution #1 bottle.
white/opaque cleaning solution bottle with warm distilled water.
Install the hose and cap from the S1 solution bottle on the
cleaning bottle and connect to the S1 port on the top of the
machine.
Open the flow control knob on the side of the machine to the fully
open position.
Turn on the S1 solution switch (press twice until lights up) and run
a full bottle of warm distilled water through the S1 side.
After running a full bottle of warm distilled water through the S1
side, disconnect the cleaning bottle from the S1 cap and hose.
You can leave the cap/hose disconnected to dry, or reconnect the
S1 bottle if you have another service that day.
Refill the cleaning solution bottle with warm distilled water.
Connect the S3 cap/hose to the cleaning bottle, and connect the
hose to the S3 port on the top of the machine.
Turn on the S3 solution switch (press twice until lights up) and run
a full bottle of warm distilled water through the S3 side.
side, disconnect the cleaning bottle from the S3 cap and hose.
You can leave the cap/hose disconnected to dry, or reconnect the
10
Fill the