Table of Contents
Advertisement
Make sure that only authorized, qualified persons operate the unit.
•
Read the owner's manual thoroughly before use.
•
Check the conditions of suction bottle.
•
Suctioned materials in the suction bottle should be removed after
•
every use.
2)
Operation and Procedures to Operate
1. Install power cord into AquaGlo Plus base machine and plug into
power source. It is recommended to plug the power cord into a
surge protection type plug in. After both ends of the power cord
have been secured into place, turn on the main power switch located
on the back of the machine above the hand set hose.
2. Press the GREEN On/Off button once for Solution 1 (green) or the
ORANGE On/Off button for Solution 3 (orange) to activate the air
suction hose. The machine will BEEP once.
3. Press the GREEN On/Off button a SECOND time for Solution 1
(green) (or the ORANGE On/Off button for Solution 3 (orange) to
start the suction/flow of the corresponding solution. The machine will
BEEP twice in succession and the button will light up.
4. Adjust the solution flow rate (- or +) and vacuum pressure (LOW of 0
to HIGH of 10) as needed.
5. Place your hand piece on the skin and gently rub over the desired
areas.
6. To stop suction/flow press the GREEN On/Off button again (or
the Orange On/Off button for Solution 3). The unit will beep
THREE TIMES in succession and the buttons will no longer light
up.
7. After finishing each session, the AquaGlo Plus System must be
cleaned using the cleaning procedure set forth below.
9
Advertisement
Table of Contents
