Installation - D-Link DBA-3620P Quick Installation Manual

Installation

POWER IN
Connect the
Power Cord
to the PoE
LAN
Adapter and a
power outlet
with earthing
connection
Connect Computer to
Ethernet Port labeled
LAN on PoE Adapter
Figure 4. Deployment Example
Configure the access point
To set up and manage the DBA-3620P, use one of
the following methods:
• LAN on DBA-3620P to Ethernet Port labeled
POE on PoE Adapter
• Connect the Power Cord to the PoE Adapter
and a power outlet
• Connect Computer to Ethernet Port labeled
LAN on PoE Adapter
DBA-3620P
• Manage the access point from the computer:
Connect the access point and your computer
directly via a straight-through Ethernet cable.
Switch or Router
DBA-3620P DWL-6720AP
• Manage the access point from the computer
via the Switch or Router: Connect the access
point and your computer to the same switch
or router.
4  D-Link DBA-3620P Quick Installation Guide
LAN(POE) on
DBA-3620P to
Ethernet Port
labeled PoE on
PoE Adapter
PoE
Computer
Computer
Computer Computer
Mounting Options
Pole Mount and Wall Mount are the two mounting
options for the DBA-3620P.
Cable Requirement
Use a Cat 5 cable with an even sheath.
The Ethernet ports on the DBA-3620P access point
cannot accept a Cat 5 cable that has an uneven
sheath; the RJ-45 connector on the cable will not fit
properly into the receptacle on the access point.
Pole Mounting Installation
Installation
1. Open the bottom panel with a Phillips screw-
driver.
2. Plug one end of Cat 5 cable into the LAN port
on the DBA-3620P, and the other end to the
port labeled POE on the PoE Adapter.
LAN (POE) CONSOLE
EXT ANT
RESET
INT ANT