Advertisement
Available languages
Available languages
3. INSTALLATION
a. Connection
1) Push the high pressure hose to the trigger gun until you hear a click (5, 7). To remove
the high pressure hose, press the release button to remove the hose.
2) Connect and screw the high pressure hose to the water outlet (6) of the machine.
3) Connect the water supply hose (2) to the water inlet (4) of the machine (note: make
sure that the fitting is installed first). The minimum recommended length for the water
supply pipe is 10 meters (but not more than 25 meters) with a diameter of 12.5 mm to
avoid back pressure and any potential damage to your appliance. Make sure it can
withstand water and a maximum pressure of 10bar (0.1Mpa). If you want to connect
your device to other water sources, make sure the maximum water inlet pressure is
10bar (0.1Mpa).
4) Plug the machine to the power supply (8).
10
Advertisement
