Inserting The Mounting Seal - Siemens SIMATIC TP700 Comfort INOX PCT Operating Instructions Manual

Installing and connecting the device

3.2 Inserting the mounting seal

3.2 Inserting the mounting seal
The following figures in this section are examples.
To prevent the mounting seal from being inserted in the wrong direction, it has an
asymmetric coding tap. On all mounting gaskets of the INOX devices, the coding tap is on the
bottom left in relation to the rear of the device.
Note
Use a new mounting seal for each installation, because the promised degree of protection
cannot be guaranteed otherwise.
Requirement
• Remove all packaging components and the edge protection tape prior to installation.
Procedure
1. Look for the coding tap on the mounting seal. Turn the mounting seal so that the coding tap
is on the bottom left as seen in the figure below:
24
① Coding tap
② Positioning hooks
③ Seal corner
Compact Operating Instructions, 07/2021, A5E38804191-AE
Comfort Panels INOX PCT