Notes On Installation - Siemens SIMATIC TP700 Comfort INOX PCT Operating Instructions Manual

Installing and connecting the device
3.1 Preparing for installation
Mounting in vertical format
The Touch HMI devices are also suitable for mounting in vertical format. Select the
appropriate screen format during configuration.
A maximum ambient temperature of +40 °C is permitted for vertical mounting (0° tilt angle);
a maximum of +35 °C is permitted for inclined mounting.
3.1.4

Notes on installation

Mounting cutout
The HMI device can be installed in control cabinets (see table for material thickness). No
special tools are required for mounting. The HMI device can be operated both in landscape
and portrait format with a vertical inclination of up to +/-35°. Due to the surrounding beveling
of the stainless steel front of 45°, liquids are able to drain off even in an inclined installation
position of +/-35°.
The following conditions apply to the mounting cutout:
The front material has to consist of sheet steel or material of a strength that corresponds to at
least the stability of sheet steel.
Mounting cutout
Material thickness
Permitted deviation from plane
This condition must be fulfilled for the mounted HMI device.
Permitted surface roughness in the area of the mounting seal
22
Compact Operating Instructions, 07/2021, A5E38804191-AE
Dimensions
1.5 to 6 mm
≤ 0.5 mm
≤ 120 µm (R 120)
z
Comfort Panels INOX PCT