Agilent Technologies N4413A User Manual page 191

ID Front Panel
Number Feature
7 COUPLER IN
8 B IN
9 R2 IN
10 R2 OUT
11 B OUT
12 SOURCE
OUT
13 POWER
14 AUXILIARY
15 SOURCE
OUT
16 A OUT
17 R1 OUT
Chapter 7
Feature Description
SMA (f) connector that is connected to the network analyzer
COUPLER IN connector using a semirigid cable.
SMA (f) connector that is connected to the network analyzer
B IN connector using a semirigid cable.
SMA (f) connector that is connected to the network analyzer
R2 IN connector using a semirigid cable. This connector is
installed on Option 103 only. It is not installed on Option 104.
SMA (f) connector that is connected to the network analyzer
R2 OUT connector using a semirigid cable. This connector is
installed on Option 103 only. It is not installed on Option 104.
SMA (f) connector that is connected to the network analyzer
B OUT connector using a semirigid cable.
SMA (f) connector that is connected to the network analyzer
SOURCE OUT connector using a semirigid cable.
ON/OFF switch that disconnects the mains circuits from the
mains supply before other parts of the test set. The front
panel POWER switch disconnects the mains circuits from the
mains supply after the EMC filters and before other parts of
the instrument.
15-pin ribbon (f) connector that may be connected to the
Agilent N4430A/B ECal module to provide ECal capability.
SMA (f) connector that is connected to the network analyzer
SOURCE OUT connector using a semirigid cable.
SMA (f) connector that is connected to the network analyzer
A OUT connector using a semirigid cable.
SMA (f) connector that is connected to the network analyzer
R1 OUT connector using a semirigid cable.
Instrument Information
Front and Rear Panels
181