Honda EU30is Owner's Manual
  1. Manuals
  2. Brands
  3. Honda Manuals
  4. Inverter
  5. EU30is
  6. Owner's manual

Honda EU30is Owner's Manual

Hide thumbs Also See for EU30is:
Table of Contents

Advertisement

Quick Links

EU30is
GENERATOR
OWNER'S MANUAL
4MZT7G100
00XTW-ZT7-A000
© Honda Taiwan Co., Ltd. 2018
2018.03
Printed in Taiwan
–
– 1
SAFETY
DO NOT USE INSIDE HOUSE!
DO NOT USE IN WET CONDITION!
DO NOT CONNECT TO
HOUSEHOLD CIRCUIT
–
– 2

Advertisement

Table of Contents
loading

Related Manuals for Honda EU30is

Summary of Contents for Honda EU30is

  • Page 1 SAFETY EU30is DO NOT USE INSIDE HOUSE! GENERATOR DO NOT USE IN WET CONDITION! DO NOT CONNECT TO HOUSEHOLD CIRCUIT OWNER'S MANUAL © Honda Taiwan Co., Ltd. 2018 2018.03 4MZT7G100 00XTW-ZT7-A000 Printed in Taiwan – – 1 – – 2...

  • Page 2: Pre-Operation Check

    KEEP AWAY FROM FLAMMABLE MATERIALS! PRE-OPERATION CHECK 1. ENGINE OIL LEVEL Check the oil level with the generator on a level surface and the engine stopped. Recommended oil: 4-STROKE MOTOR OIL SAE 10W-30 API Service category SE or later WHEN REFUELING: STOP ENGINE! DO NOT SPILL! NO SMOKING!

  • Page 3: Fuel Level

    2. FUEL LEVEL 3. If the oil level is lower than the upper level, fill with the recommended oil to the upper level. Never use an oil/gasoline mixture or dirty gasoline. OIL FILLER CAP FUEL TANK CAPACITY: 13L 1. Check the fuel level. 2.

  • Page 4: Air Cleaner

    3. AIR CLEANER STARTING THE ENGINE 1. Turn the fuel valve lever to the "ON" position. 1. Open the left side maintenance cover. Unsnap the four clips and remove the air cleaner cover. 2. Check the air cleaner elements to be sure they are clean and in good condition.

  • Page 5: Choke Knob

    4. Pull the starter grip lightly until resistance is felt, then pull the starter grip 6. If the choke knob was pulled to the CLOSED position, push to the OPEN briskly in the direction of the arrow as shown. position as the engine warms up. CAUTION: OPEN Do not allow the starter grip to snap back.

  • Page 6: Generator Use

    Eco Throttle System GENERATOR USE To keep the generator always in top mechanical and electrical condition, The Eco throttle system automatically reduces engine speed when all loads observe the following. are turned off or disconnected. When appliances are turned on or Combined load of the connected apparatus must not exceed the rated reconnected, the engine returns to proper speed to power the electrical load.

  • Page 7: Output Indicator

    Rated power in parallel operation is: Output and Overload Indicators EU30is: 5,600 VA The Output indicator (green) will remain ON during normal operating conditions. If the generator is overloaded, or if there is a short circuit in the connected...
  • Page 8 4. Confirm that the equipment to be used is switched off, and insert the plug 1. Connect the special cable/receptacle for parallel operation to the two generators. of the equipment to be used into the receptacle of either unit A or B. Be sure to ground the generator when connected equipment is grounded.

  • Page 9: Dc Circuit Protector

    DC Application 2. Make sure the DC circuit protector is ON. The DC receptacle may be used for charging 12 volt automotive type DC CIRCUIT PROTECTOR batteries only. Always use only the charging cable (sold separately). 1. Connect the charging cable to the DC receptacle of the generator and then connect to the battery.

  • Page 10: Stopping The Engine

    These items should be serviced by your servicing dealer, unless you have the 3. Turn the fuel valve lever to the "OFF" position. proper tools and are mechanically proficient. Refer to Honda shop manual for ser- FUEL VALVE LEVER vice procedure.

  • Page 11: Engine Oil Change

    ENGINE OIL CHANGE 1. Remove the oil maintenance cover (P. 4). 2. Remove the oil filler cap and drain plug to drain the oil. 3. Install the drain plug and tighten it securely. DRAIN PLUG 4. Fill to the upper level with the recommended oil (P.

  • Page 12: Air Cleaner Service

    AIR CLEANER SERVICE 4. Remove the foam element from the air cleaner cover and clean it. 1. Open the left maintenance cover. FOAM ELEMENT 2. Unsnap the four clips and remove the air cleaner cover. Wash the air foam element in a solution of household detergent and warm water, then rinse it thoroughly.

  • Page 13: Spark Plug Service

    SPARK PLUG SERVICE 3. Clean the spark plug with a wire brush. Recommended spark plug: BPR6ES (NGK), W20EPR-U (DENSO) 4. Measure the plug gap. Correct as necessary by bending the side electrode. Spark plug gap: 0.7 - 0.8 mm CAUTION : Never use a spark plug with an improper heat range. ∼...

  • Page 14: Sediment Cup Cleaning

    6 mm cap nuts reverse order of removal, then install the paper element and air cleaner cover. BATTERY SERVICING 6 mm NUT Consult an authorized Honda dealer for battery servicing. 6 mm BOLT AIR CLEANER CASE 2 – – 7 2 –...

  • Page 15: Troubleshooting

    Clean, readjust and drain the carburetor. good condition? dry the spark plug. Replace if necessary. Take the generator to Honda dealer. No Electricity 1. Is the output indicator Is the overload indicator on? Take the generator to Honda dealer. 3. Change the engine oil (P. 22).

  • Page 16: Specifications

    SPECIFICATIONS Model EU30is Type Rated voltage 120 V Rated frequency 60 Hz Rated current 23.4 A Rated output 2,800 VA Maximum output 3,000 VA Voltage Current Stop the engine and let cool before refueling. The engine emits toxic poisonous carbon monoxide gas.

Table of Contents