Yellow
Teal
Purple
Flickering Blue
Flickering Red
Flickering White
Flickering Green
Flickering Yellow
Menu details
Each setting in the menu is detailed in this list:
De-bounce (Blue)
The de-bounce setting of your marker is used to control the amount of "bounce" in your trigger. A very low
de-bounce setting will result in a lot of bounce. In some tournaments or fields, it will be necessary to reduce
the amount of bounce by increasing the de-bounce setting. Always increase the de-bounce slowly, because
settings higher than 15 will result in your marker feeling unresponsive.
Dwell (Red)
The dwell setting controls the amount of time that your solenoid is held open. A very low dwell will result in
very poor performance from your marker, whilst a very high value will result in a very slow maximum rate of
fire and excess air usage. The factory setting is recommended as a base line, you may use small increments
for fine tuning.
Fire mode (White)
Your marker is equipped with 8 different fire modes. These fire modes will allow you to use your marker in
many different situations – tournament play, recreational and scenario. Always follow the rules and local
regulations when selecting your fire mode. The available fire modes are given below:
-
1 Uncapped semi
-
2 Capped semi
-
3 Uncapped
-
3 shot burst
-
4 Capped
-
3 shot burst
-
5 Uncapped full auto
-
6 Capped full auto
-
7 (unused)
-
8 (unused)
-
9 Capped PSP
-
10 Capped Millennium
Ball settle delay (1/2ms increments)
Anti-mechanical bounce
Anti-bolt stick
Factory Setting
Cycle filter
Eye mode
Bolt tracking delay (MS)
Test mode dwell (MS)
15
2
3
-
2
2 (forced)
10
2
Need help?
Do you have a question about the DRONE DX and is the answer not in the manual?
Questions and answers