Table of Contents
Advertisement
P/N 0520677_W
Front Shipping Brace
SHIPPING BLOCK(s)
Shipping block(s) must be removed before
operating cases(s).
Locate and remove the shipping block(s) near
the heat exchanger as shown below.
This block was installed to minimize shipping
vibration. Remove the bottom display pans
and air return grilles from the case(s).
Interior View of Case Bottom
OPTIONAL FORKLIFT POCKETS
(not for RFLTM)
Underneath the case there are pockets where
the forks of a forklift can be inserted to move
the case into the store. Ensure forks are inserted
through all four pockets prior to moving the
merchandiser. These shipping pockets (if
ordered with the case(s)) can be used to bring
the merchandiser into the store and place it to
its final location.
HUSSMANN CORPORATION • BRIDGETON, MO 63044-2483 U.S.A.
Ensure the forks are inserted all the way
through all four pockets before lifting the
case. Case tipping could cause personal
injury and / or damage to the equipment.
Optional Fork
Lift Pockets
MOVING MERCHANDISER THROUGH
NARROW STORE ENTRANCES
Some exterior merchandiser parts may be
disassembled for transit access through small
doors or passage ways. The minimum door
opening is 36 in. x 83 in. This procedure takes
approximately 30 minutes to disassemble and
reassemble one case. Contact your Hussmann
representative to see if store merchandisers
have this kit option.
Follow the steps below to decrease the
Freedom profile for narrow access:
1. Remove the door handles.
Remove
Screws from
Door Handle
Freedom Line Reach-in
1-3
Advertisement
Table of Contents
