Table of Contents
Advertisement
P/N 0520677_W
7. Slide the wireway pan out, and remove
it from the case. Bumper brackets and
supports are attached to wireway pan.
Removing the pan will remove the entire
assembly.
(Optional)
8. Remove the back, external braces from the
rear of the case as shown below. Braces will
slide straight back away from the case when
nuts and screws are removed.
6 nuts and 1
bottom screw per
external brace
Bottom screw is located approximately
10 inches inboard from the rear of the case.
Bottom screw location on removed rear
brace.
HUSSMANN CORPORATION • BRIDGETON, MO 63044-2483 U.S.A.
9. The splashguard panels and case facade
can be removed from the top of the case to
provide clearance for door openings.
10. Remove the piping cover plate from the
top of the case (6 screws).
1
Cover Plate
11. Pull the hoses to the inside of the case.
Avoid bending tubing sharply to prevent
damaging the tubes.
A. Check that all wiring is secured inside of
the case and wireway.
B. Check that all hoses are tucked away.
C. Use tie-wraps to secure any loose wires
or hoses.
Do not suspend these components by their
wire conduits. The case height without these
components installed on top is 82.75 in. (2102 mm).
Case depth is 35.5 in. with handles, raceway
pan and external frames removed.
NOTE: Care must be taken to ensure that
insulation is not damaged during removal or
replacement.
Front of Case
Rear of Case
Freedom Line Reach-in
1-5
Advertisement
Table of Contents
