GE Zoneline AZ95E Owner's Manual And Installation Instructions page 26

Setting the auxiliary control
Mode 3 Freeze Sentinel / Heat Sentinel
With power to the unit and Freeze Sentinel activated,
the unit automatically provides heat without user
interface. This prevents potential plumbing damage by
turning the heater and indoor fan ON at 41ºF and then
OFF once the closet temperature reaches 46ºF.
When Heat Sentinel is activated, the unit automatically
provides cooling without user interface. This prevents
an excessively hot room by turning the air conditioner
ON at 85ºF and then OFF once the room temperature
reaches 80ºF.
Press MODE until a 3 appears in the first digit of the
display for Freeze Sentinel mode. Press the - pad for
OFF " " or the + pad for ON "
the second digit of the display. Press MODE again to
access the Heat Sentinel settings. Press the - pad for
OFF " " or the + pad for ON "
to lock in your selection and exit AUX SET mode, or
press MODE to continue setting other functions.
In the default setting for Mode 3, Heat Sentinel is off,
Freeze Sentinel is on.
NOTE: These functions are active whenever the unit is
plugged in, even if the unit is turned off.
Mode 4 Constant ON Fan
Press MODE until a 4 appears in the first digit of the
display to set the fan to run continuously at high speed
- even if the unit is turned off.
Press the - pad for OFF "
This is shown in the second digit of the display.
Press AUX SET to lock in your selection and exit AUX
SET mode or press MODE to continue setting other
functions.
The default setting for Mode 4 is OFF.
26
". This is shown in
". Press AUX SET
" or the + pad for ON "
Freeze Sentinel OFF
Freeze Sentinel ON
Heat Sentinel OFF
"
Constant
Fan OFF
Heat Sentinel ON
Constant
Fan ON
49-5000561 Rev. 1