Braun Syncro 7680 User Manual page 5

Display
The pilot light shows that the shaver is connected to the
mains.
The display shows the operation mode and charging
conditions of the shaver: During charging the display
shows the battery capacity symbol increasing by 20%
segments and the remaining charging time (flashing):
First charging (4 h):
The display counts down in 20 min. steps.
Subsequent chargings (1 h):
The display counts down in 5 min. steps.
The battery is fully charged. «SmartLogic» inside monitors
the battery and communicates «Test...ok» when it is still
well charged. Below 10 minutes remaining shaving time,
the display shows the minutes left. The «moving» plug
symbol indicates that you should charge your shaver. If
there is insufficient battery charge for a cordless shave,
either recharge the shaver or shave via the lpower supply
cord connected to the mains.
*
The display changes to this format when the shaver is in
*
the Clean&Charge.
The «SmartLogic» inside your shaver automatically
monitors the condition of the batteries as well as the
charging/dis-charging processes and adapts them to your
personal shaving patterns. For instance, if it is your routine
to never let the batteries run low, the «SmartLogic» will
recognize this, look for a pause when you are likely to not
use the shaver and completely discharge and then
recharge your shaver to recondition the batteries (every six
months at the most, and only when necessary).
For additional information, press the info key:
press once:
– to display the duration of the last shave
5