Advertisement
Preparing the carpet
1. Thoroughly clean the carpet with a vacuum cleaner using a brush
attachment if possible.
2. If possible remove all furniture from the carpet, in the case of large
items of furniture which cannot be moved, place plastic film around
the feet and only remove once the carpet is fully dry to avoid damage
caused by moisture from the carpet.
3. Check the colourfastness of the carpet. Soak a piece of white
fabric with the cleaning solution to be used and rub it carefully on an
inconspicuous spot on the carpet. If the white fabric does not become
discoloured the carpet can be cleaned with the appliance. If the carpet
has more than one colour, test the fastness of all of the colours.
Preparing the Carpet Washer
Note: It is recommended Daewoo carpet cleaning fluid is used with
this appliance. For details of Daewoo carpet cleaning fluid and stain
remover spray contact
Do not use foaming cleaning fluids as the foam may impede the
functioning of the Carpet Washer.
1. Ensure the Carpet Washer is switched off and disconnected from the
mains supply before filling with water.
2. Remove the filler cap from the clean water tank and pour in cleaning
fluid as directed on the packaging.
3. Add 1.5 litres of warm water (approx 40
4. Plug the Carpet Washer into a suitable socket outlet.
5. Decide where the cleaning will begin and end in order to avoid
stepping on the wet carpet. It is recommended that right handed
people start at the right hand edge of the carpet and left handed
people start at the left hand edge.
6. Press the main power switch to on, this will illuminate to indicate there
is power to the unit and the heater at the rear of the unit.
7. Step on the handle release pedal and tilt the handle back towards
you.
8. Position the Carpet Washer at the cleaning start point.
help@daewooelectricals.com
Hurricane CAT3 Carpet Washer
FLR00054
User Manual
C) and replace the filler cap.
o
Advertisement
