Advertisement
9. Step on the ON/OFF switch to start the appliance.
10. Push the Carpet Washer forward whilst pressing the fluid release
trigger on the handle. Walk to the side of the appliance as you do this.
Do not step on the wet carpet.
11. Once the end of the carpet is reached, release the fluid release trigger
and pull the cleaner backwards along the same strip to suck up the
dirty water.
12. Start the next strip slightly overlapping the cleaned strip and repeat
this process until the whole carpet is cleaned.
13. For stubborn stains use a stain removal spray to pretreat the carpet
before cleaning.
14. Do not allow the dirty water tank to fill above the MAX level mark.
15. Empty both water containers after each use.
16. Allow the freshly cleaned carpet the dry thoroughly.
17. When the carpet has fully dried, vacuum with a conventional vacuum
cleaner, with a brush attachment if possible.
Note: If the appliance switches off during use, the built in overheat
device has activated. In this case, switch the appliance off and
disconnect from the mains and allow to cool for 60 minutes before
using again.
1.
2.
Remove the rubber bung at
the top of the tank and pour
away the dirty water.
Thoroughly rinse the tank
with clean water before
refitting to the main body.
To empty the dirty water tank, press
down on the dirty water tank release
handle and pull the tank away from
the main body as shown left.
Hurricane CAT3 Carpet Washer
FLR00054
User Manual
Advertisement
