Breville Fast Slow GO Instruction Book page 21

• Time will start counting down and preheat
LED will not be illuminated during
DELAY START.
ALTITUDE ADJUST
Pressure builds and increases when the
temperature inside the cooking vessel exceeds
boiling point. As altitude increases, the
temperature at which water boils decreases as
a result of the drop in air pressure. This creates
very different conditions for cooking when
using a pressure cooker.
In order to maintain consistent cooking results
at various altitudes, the Fast Slow GO™ has an
Altitude Adjust feature that adjusts the settings
based on the altitude of your current location.
1. To enter Altitude Adjust, press and hold
both the DELAY START and KEEP WARM
buttons for 2 seconds.
2. Press the TIME (+/-) buttons or the
PRESSURE/TEMPERATURE (+/-) buttons
to adjust altitude in 1000 feet increments..
3. Four-digit display shows 'Alt' and number,
switching every 1 second.
4. Press START button to confirm and a beep
will sound.
5. The cooker's settings have now been
adjusted for your current altitude. Pressing
any button or quitting after timeout will
save the current set altitude value. To
change altitude to factory settings, adjust
the altitude back to 0 feet.
NOTE
Exact altitude can be found at
www.elevationmap.net or by contacting
Breville Customer Service Center.
SETTING THE UNIT MEASURE
The unit measure default is in Fahrenheit
(F). To change between imperial and metric
units, press the PRESSURE/TEMPERATURE
(+/-) buttons for 5 seconds and the display will
show C for Celsius. Press the PRESSURE/
TEMPERATURE (+/-) buttons again for 5
seconds to revert to Fahrenheit and the display
will show F.
21