Table of Contents
Advertisement
Choose to ignore the DEL control code (7Fh) when received or to treat it as a Destructive Backspace code.
Send ACK: [Off, On ]
Decide whether the terminal should respond to inquiry (05h) or when certain terminal functions are performed
(configuring the EIA (Aux) ports, splitting screen, etc.) with the ACK (06h) character.
Null Suppress: [On, Off]
In the default mode, the host ignores all received NULLs (00 hex). When off is selected, the terminal will accept
all received NULLs, and act upon them according to the selected emulation.
Send Line Term: [<US>, <CR><LF>]
Select which line terminator is sent. <US> is 1Fh and <CR><LF> is 0Dh 0Ah.
Local: [Off, On]
Select whether keyed data is interpreted locally by the terminal and not sent to the host. Data sent by the host
is lost, if Local is on. The ability to print data is not affected by this mode.
Send Block Term: [<ETX>, <CR>]
Select which character will indicate the end of a block. The choices above are for ASCII emulations. ANSI
emulations have the following choices: [None, FF].
Send End: [Cursor, Region]
Select whether the end is indicated by the scroll region or by the cursor location.
Send Region: [Screen, Scroll]
Choose whether the terminal sends data from the entire screen or from the scrolling region.
Ignore CTS: [Off, On]
Ignore CTS is not displayed in IBM 3151 emulations
Line Control: [CRTS, PRTS, IPRTS]
PRTS* (permanent request to send) – PRTS handles the CTS and DSR signal as modem signals.
IPRTS* (induced permanent request to send) – IPRTS handles the CTS and DSR signals as if the signals are
always on.
CRTS* (controlled request to send) – CRTS looks at the CTS, DSR and CD signals to determine when the
terminal can send or receive data.
* PRTS and IPRTS require full duplex communication capabilities. CRTS requires half duplex communication
capabilities.
Turnaround Char: [<ETX>, <CR>, <EOT>, <DC3>]
The line turnaround character is attached to the end of a data stream when one of the read commands is
received or one of the following keys is pressed:
Send
Reset (if reset attn is enabled)
Print (if print key attn is enabled)
Print line (if print key attn is enabled)
Print Msg (if print key attn is enabled
Send Null Suppress: [Off, On]
Off – Trailing null characters are converted to space characters when data is sent to the host system.
On – Trailing null characters are removed when data is sent to the host system.
Print: F8
Print Mode: [Normal, Auto, Controller]
Select the way in which printing is controlled.
Normal indicates that printing is to occur when a print request (such as print screen) is received.
Auto prints a line when the terminal receives a LF, a FF, or a VT code, or when autowrap occurs.
Controller indicates that host data is sent to the printer (pass through mode). Printing is controlled by the
host computer.
Print Block Term: [<ETX>, <CR>]
Send Line
Clear
F1 thru F36
PA1 thru PA3
Sn Msg
Setup
34
Advertisement
Table of Contents
