Daikin FXMQ-MF Engineering Data page 4

EDUS39-900-F10
•The unit introduces outdoor air and adjusts
the outdoor air temperature via fixed discharge
temperature control, thereby reducing the air
conditioning load.
* The system can operate with outdoor-air temperatures ranging
from 23 to 109.4˚F. Heating performance is somewhat adversely
affected when the outdoor-air temperature is 32˚F or below.
* When shipped from the factory, the thermostat is set at 64.4˚F
for cooling and 77˚F for heating. The set temperature can be varied
within the range of 55.4–77˚F during cooling operation, and
64.4–86˚F during heating operation, in the local setting mode using
the wired remote controller. The temperature, however, is not
displayed on the remote controller.
* While in machine protection mode and depending on outdoor air
conditions, discharge air temperature may not be at the set
temperature.
* The fan stops when operating in defrosting, oil returning and hot
start operations. The fan also may stop due to mechanical protection
control.
• Ceiling mounted duct units with three differing
capacities are available. These can be connected
to VRV series outdoor units to meet a variety
of different requirements.
Airflow rate
FXMQ48MFVJU
FXMQ72MFVJU
FXMQ96MFVJU
• Optional equipment includes long-life filters.
• Compatible with outdoor temperatures from 23˚F to
109.4˚F.
Usage Limitations
23
Notes
1. The data shown in the graph illustrates the supported operation ranges under
the following conditions.
Indoor and Outdoor Unit
Effective piping length: 25ft.
Height differential: 0ft.
2. The discharge temperature can be set using the remote controller. However,
the actual temperature may not match the temperature setting under some
circumstances due to the outdoor-air processing load or mechanical protection
controls.
3. The system will not operate in fan mode when the outdoor air temperature is
41˚F or below.
FXMQ-MF
(cfm)
635
988
1,236
Supported Cooling
Operation Range
Fan
Operation
59 66.2 (92.3)
• High-performance filters with dust collection
efficiencies (JIS calorimetry) of 90% and 65% are
also available as options.
• As with the VRV
a variety of control systems can
be deployed, including remote
control from distances of up to
1640 ft 5 in.
* Group control is not possible between this
unit and standard type indoor units.
Connect remote controllers to each unit.
• The "self-diagnosis function" indicates the occur-
rence and nature of abnormalities in the system
by displaying codes on the remote controller.
• A central control system
compatible with the VRV
system can be installed.
* It is not possible to change the
discharge air temperature settings
from the central control system.
* Do not associate this equipment
into zones with standard indoor units,
as central control will not be possible.
• As with the VRV
the "super wiring system" so that the wiring linking
indoor and outdoor units can also be utilised for
central control.
Notes:
* Linked control of the product and the HRV is not supported.
* This equipment is intended for the treatment of outdoor air only.
It is not to be used for maintaining indoor air temperature. Install
and use with standard indoor units. Be sure to position the air
discharge openings of the product in positions where the airflow
will not blow on people directly. When outdoor-air processing is
in excess, the unit switches to thermo-off mode, and outdoor air
flows into the room directly.
* For outdoor ducts, be sure to provide heat insulation to prevent
condensation.
* Group control of the product and the standard indoor units is not
supported. A separate remote controller should be connected to
each individual unit.
* The system will not operate in fan mode when the outdoor air
temperature is 41˚F or below.
109.4
* If the product is allowed to operate 24 hours a day, maintenance
(part replacement, etc.) must be performed periodically.
* Temperature setting and Power Proportional Distribution (PPD)
are not possible even if the intelligent Touch Controller or the
intelligent Manager III is installed.
* The remote controller wired to the outdoor-air processing unit
must not be set as the master remote controller. Otherwise,
when set to "Auto," the operation mode will switch according to
the outdoor air conditions, regardless of the indoor temperature.
system,
BRC1E71
Wired remote controller
(option)
DCS302CA71
Central remote controller
(option)
system, the equipment employs
Features
3