Table of Contents
Advertisement
8.2
Connecting cables
8.3
Mounting the base
Building Technologies
Fire Safety & Security Products
It is recommended to use a cable type IYSTY (Twisted Pair) 2 x 2 x Ø 0.6 mm or
larger diameter.
1. Insert the cable through the cable entry hole [ 10] in the base.
2. If necessary, carefully remove the breakout pieces [ 10] .
3. Connect the individual wires to the screw terminals.
Connections
Contact pin
Abbreviation Function
1
A/+
2
B/-
3
+
4
-
5 to 10
Attach the cable with a cable tie.
Cable tie
Make sure to mount the unit only on surfaces that are sufficiently hard and rigid.
1. Mark 3 holes for the mounting screws [ 10] and one for the tamper contact
[ 10] .
2. Drill the holes and screw the base.
RS485
RS485
+ Vin
- Vin
Not connected
Installation
020_ATI5100_A6V10235012_a_en
23.09.2009
13
Advertisement
Table of Contents
