Advertisement
Step Four
Two persons required.
Please position (02), (03), (04) and (08) parts as shown in the picture. All fittings (A) must go into
prepared holes with the cam. Side panels (02), and (03) must attach to the shelf (04) and base (08)
according to the arrows direction shown. If cams don't lock into place please use screwdriver to adjust
them. After all pieces are pre assembled, please use a screw driver to tighten up all the components.
Close
_____________________________________________________________________
Step Five
Two persons required.
Please position the assembled wardrobe components vertically on the base of the wardrobe, as
shown in the diagram. Support (06) and front (09) must attach to wardrobe frame according to the
arrows direction shown. Tighten up the attached parts with screw driver.
If the locking device is closed please
ensure you open it as shown below
Open
6
Advertisement
