Controls - Husqvarna K3600 Mk II Workshop Manual

502 53 06-26

CONTROLS

Remove the handle halve
Remove the screws.
Remove the controls
Fit a 5 mm Allen key, as shown
in the picture, to hold the units
together.
Remove the handle halve
Move the handle to the forward position.
Remove the handle half screws.
First, separate the handle at the rear, by
the controls, to release the control shafts
from the handle half.
Then move the handle half back to release
it from the front section of the machine.
Fitting components
The picture shows how the components
in the handle half must be fitted.
Note that the start control link rod is
located below the incoming water pipe.
Remove the controls
The controls come in two parts that,
when dismantled, are difficult to handle.
In addition, there is also a spring on the
underside.
The following arrangement facilitates
removal and fitting of the controls: Fit a
5 mm Allen key, as shown in the picture,
to hold the units together.
Remove the start control shaft with a
pair of pliers.
Pull the start control link rod to opera-
tional position. Lift the controls out of
the handle half and unhook the controls
from the link rod.
10
17