Graco 24V641 Instructions Manual page 8

E MACHINE AND MANUFACTURER IDENTIFICATION
EN
WARNING
E.1 PLATES POSITION
NOTICE
nlr
m
8
The dispensing system comes with an identific tion plate; this
is attached to the pump and contains the following informa-
tion:
type:
lot number / Production year;
technical data;
instruction manual part number
EQUIPMENT MISUSE HAZARD
Before installing, always make sure the type of dispensing
system is correct and suitable for the available power supply
(Voltage/Frequency.)
The dispensing system is equipped with decals and/or plates
to provide operators with the necessary important informa-
tion. Make sure that these do not deteriorate or become de-
tached over time
Replacement label PNS 189930 and 15K616 are
available at no cost
F
.
189930 15K616
Graco Inc.
P.O. Box 1441
Mpls, MN 55440
MADE IN ITALY
24V641 XXXX
MAX WPR 345 kPa (3.4 bar)(50 psi)
120V 60Hz 500 W
4.5A 1730 Rpm
DUTY CYCLE 20´ON/20´OFF
34 lpm/9 gpm
-5C to 40C 23F to 104F
IP55
LOT XXXXXXX
www.graco.com
Read instruction manual 333470.
M0312