Advertisement
Quick Links
ELITE XT - HOW TO INCREASE CLAMPING FORCE
INSTRUCTIONS
1) REMOVE SUPPORT rod. Open to screws with hexagonal key.
3)
CLEAN BOTH LOCKING UNITS (inside the clamp)
and lubricants. Clamp works the best with none or VERY little
amount of oil. Use solvent if necessary.
4) ATTACH SUPPORT ROD and fasten screws.
2)
CLEAN GUIDE RODS
Remove clamp from guides if necessary.
Clamp works optimally with VERY little amount
of oil. Use solvent for cleaning if necessary.
from oil
Page 1 of 3
from oil or lubricants.
Locking unit
(Inside the clamp)
Area to be cleaned is
shown here: precision
hole.
www.maping.com
Advertisement
Related Manuals for Fastbind ELITE XT
Summary of Contents for Fastbind ELITE XT
- Page 1 ELITE XT - HOW TO INCREASE CLAMPING FORCE INSTRUCTIONS 1) REMOVE SUPPORT rod. Open to screws with hexagonal key. CLEAN GUIDE RODS from oil or lubricants. Remove clamp from guides if necessary. Clamp works optimally with VERY little amount of oil. Use solvent for cleaning if necessary.
- Page 2 ELITE XT - HOW TO INCREASE CLAMPING FORCE INSTRUCTIONS 5) Clamp strength adjustment: Retaining screw Tighten clamp: turn clockwise both left and right locking has to to adjust clamping Loose clamp: turn counter be adjusted!!! strength. Use clockwise. 2,5 mm hex key.
- Page 3 ELITE XT - HOW TO INCREASE CLAMPING FORCE INSTRUCTIONS Down 10) Check that clamp moves smoothly from down to up position. If clamp is too tight, it does not move smoothly up. Then loosen adjustment screws. If clamp moves smoothly from down to up...