Lcd Setting - INFOSEC E6 LCD 10K TM RM User Manual

OPN
RES
N.L
CHE
OP.V
PAR

3-7. LCD Setting

There are three parameters to set up the UPS. Refer to following diagram.
Parameter 1
Parameter 2
Note: The following order of setting code only presents when UPS is in Bypass Mode or no-output mode. The
setting code number will change the numbers under other modes. For example, when the UPS is in AC mode, the
total available setting becomes 7 only. Then, setting code of "Bypass mode setting" will become 01, "Battery backup
time setting" will become 02, and so on.
INFOSEC UPS SYSTEM – 4 rue de la Rigotière – 44700 Orvault – France – www.infosec-ups.com
Hot Line Tel : +33 (0)2 40 76 15 82 – fax : +33(0)2 40 94 29 51 – hotline@infosec.fr – 03 15 37 59 204 03
Parameter 3
Allow
Reserved
Neutral line loss
Check
Output voltage
Parallel, 001 means the first UPS
Parameter 1: It's for program alternatives.
Refer to below table.
Parameter 2 and parameter 3 are the setting
options or values for each program.
40