Viavi T-BERD 5800 Quick Card page 4

Run Test:
1.
Tap the Results icon.
2.
Tap the Start/Stop key to start the test. After auto-configuration, the OTDR will perform a
connection check to ensure that the connection is Good. If the Connection is Bad, repeat steps 1
through 7 on page 2.
3.
The T-BERD will perform acquisitions at two wavelengths and the trace file will be saved to disk. Results
may be displayed in 3 different formats: Trace view, SmartLink Summary View, or SmartLink Event View.
Tap the Trace/SmartLink soft key
Tap the
a.
Trace view: Results for each wavelength are shown in different
colors in the top section of the display. Each event is listed in
the lower section of the display. Any events that violate
pass/fail thresholds for loss or reflectance are shown in RED.
Use the right and left arrow keys
Toggle between results for each wavelength. Tap the Zoom soft
key , to enable the following zoom controls:
•
•
b. SmartLink Summary view: The FUT is displayed as a series
of icons representing events (connectors, splices, bends,
etc.). The center of the display shows summary results per
wavelength for the entire span. Acquisitions for which all
events are acceptable are marked with a green check
Acquisitions with events that exceed pass/fail thresholds
for loss or reflectance are marked with a red
lower display shows each event that exceeds thresholds.
c. SmartLink Event view: The FUT is displayed as a series of
labeled icons representing each event in the trace:
• BBU: Connection (coupler) between launch cable and
BBU Jumper Cable
• BOT TWR: Optical Patch Panel at bottom of tower
• TOP TWR: Junction Box/Patch Panel at Top of tower
• RRU: End of RRU Jumper Cable
Any events that violate pass/fail thresholds for loss or
reflectance are shown in RED. Tap on any event to display
details in the lower display.
4. Repeat steps 2 and 3 for all Fibers under test.
Contact Us +1 844 GO VIAVI
(+1 844 468 4284)
, to toggle between Trace view and SmartLink views.
soft key to toggle between the SmartLink Summary view and SmartLink Event View:
Toggle between automatic zoom and full trace view
Expand and contract trace.
To reach the VIAVI office nearest you,
visit viavisolutions.com/contacts.
in the control panel to
.
. The
VIAVI Solutions
Figure 7: Trace view
Figure 8: SmartLink Summary View
Figure 9: SmartLink Event View
© 2018 VIAVI Solutions Inc.
Product specifications and descriptions in this
document are subject to change without notice.