Viavi T-BERD 5800 Quick Card page 3

Launch Test:
Figure 5: Home View
1. Press the Power button to turn on the T-BERD/MTS-5800.
2. Tap the Fiber Optics icon in the Status Bar at the top of the display.
3. Tap the Home icon to display the Home view with FTTA OTDR icons.
4. Tap the desired (Multimode or Single Mode) FTTA OTDR icon until it is yellow and highlighted.
5. If files are to be saved, tap the File icon in the Control Panel, and tap the fiber folder
Otherwise, proceed to step 7.
6. Tap the Create Directory soft key, enter a name for your new folder, and tap the Enter key. All
trace files will be saved to this directory.
7. Tap the Setup icon in the Control Panel. If an FTTA_RRU_Maintenance configuration file has
already been loaded, proceed to Step 10.
8. Tap the Load Config soft key. Select FTTA_RRU_Maintenance.SM-OTDR for single mode fiber,
or FTTA_RRU_Maintenance.MM-OTDR for multimode fiber.
9. Tap the Load as FTTA Config soft key.
10. Tap the Analysis soft key:
• Set BBU Jumper to Yes if there is a BBU Jumper Cable between the Launch Cable and OPP;
Set BBU Jumper to No if the Launch Cable is directly connected to the OPP.
• Set RRU Jumper to Yes if there is a Junction Box/OPP at the top of the tower between the
Trunk Cable and RRU; Set RRU Jumper to No if there is no Junction Box or no RRU Jumper.
• Leave other settings at default values.
• Tap the Analysis title bar to display the Link soft key
11. Tap the Link soft key:
• Set Base Station ID to the Base Station or BBU Identifier
• Set RRU ID to the RRU Identifier or sector (Alpha, Beta, Gamma)
• Set Fiber Code to the fiber number and polarity using the right ( < ) and left ( > ) arrow
buttons.
• Set Change Fiber Nbr to Increment.
• Set Distance Unit to Feet or Meters.
VIAVI Solutions
Figure 6: File menu
.