Packing And Shipping The Machine - Brother MFC-297C User Manual

Packing and shipping
the machine
When you transport the machine, use the
packing materials that came with your
machine. Follow the instructions below to
properly pack your machine. Damage caused
to your machine during transit is not covered
by your warranty.
CAUTION
It is important to allow the machine to 'park'
the print head after a print job. Listen
carefully to the machine before unplugging
it to make sure that all mechanical noise
has stopped. Not allowing the machine to
finish this parking process may lead to print
problems and possible damage to the print
head.
a
Open the ink cartridge cover.
b
Press the lock release lever to release
the ink cartridge and take out all the ink
cartridges. (See Replacing the ink
cartridges on page 100.)
c
Install the green protective part, and
then close the ink cartridge cover.
108
CAUTION
Make sure that the plastic tabs on both
B
sides of the green protective part (1) have
securely clicked into place (2).
1
If you are not able to find the green
protective part, DO NOT remove the ink
cartridges before shipping. It is essential
that the machine be shipped with either the
green protective part or the ink cartridges in
position. Shipping without them will cause
damage to your machine and may void your
warranty.
d
Unplug the machine from the telephone
wall socket and take the telephone line
cord out of the machine.
e
Unplug the machine from the electrical
socket.
f
Using both hands, use the plastic tabs
on both sides of the machine to lift the
scanner cover until it locks securely into
the open position. Then unplug the
interface cable from the machine, if it is
connected.
2