Toshiba GX7R ASD Quick Start Manual page 63

7. Command Source
This selection establishes the source of the Run commands (e.g., F, R, Stop, etc.).
Settings:
0 — Terminal Board
1 — CN8 Option (Not Used)
2 — TTL
3 — RS232/RS485
4 — Communication Card
8. Frequency Command Source
This selection establishes the source of the Frequency (speed) command.
Settings:
1 — VI/II
2 — RR
3 — RX
4 — RX2 (option)
5 — CN8 Option (Not Used)
6 — Binary/BCD Input
7 — TTL
8 — RS232/RS485
9 — Communication Card
10 — UP/DOWN Frequency
11 — Pulse Input (option)
9. Wizard Finished!
This screen is the final screen of the Startup
Wizard. The basic parameters of the GX7R ASD
have been set. Click Exit to load the Startup
Wizard input and to return to the Frequency
Command screen. Additional application-specific
programming may be required.
GX7R ASD Quick Start Guide 55