Removing The Existing Outdoor Control Panel - Pentair EasyTouch Appliance Upgrade Manual

EasyTouch/IntelliTouch Control System Legacy Upgrade Kits Installation Instructions
4

Removing the Existing Outdoor Control Panel

The following upgrade installation instructions are for EasyTouch
IntelliTouch Control Systems using the 2003-2012 (horizontal low voltage circuit breakers
configuration on bezel) Load Center or Power Center.
RISK OF ELECTRICAL SHOCK. BEFORE REMOVING THE HIGH VOLTAGE
COVER PANEL FROM THE ENCLOSURE SWITCH OFF THE
MAIN POWER AT THE HOME AT THE MAIN CIRCUIT BREAKER BOX.
1. TURN OFF POWER TO ALL POOL AND SPA EQUIPMENT BEFORE STARTING.
CAUTION! DO NOT PLUG IN OR UNPLUG ANY SYSTEM COMPONENTS WITH THE
POWER ON. THIS MAY DAMAGE THE SYSTEM COMPONENTS.
2. Unlatch the front door latch. Open the door of the Load Center or Power Center.
3. Remove the two screws securing the High Voltage Cover Panel. Remove the panel and set
aside.
4. Loosen the two retaining screws securing the existing control panel. Fold down the panel to
access the circuit board low voltage connections and transformer connector.
Continue to next page
Retaining screw
Bezel screw
Note: Refer to page 3 where (parts index number) is shown
WARNING!
Front
door
Figure 2. Load Center or Power Center (2003-2012)
PL4/PSL4, EasyTouch or
®
Retaining screws
(for High Voltage
Cover Panel)
High Voltage
Cover Panel
Three Tabs/Slots
Retaining screw
Bezel screw