Delta EVODECK EC Installation And Maintenance Instructions Manual page 28

Validation of the direction of rotation of the
axle:
After having assembled the slat cover on the
surface of the pool and having attached it to the
axle (straps), insert the key into the switch and turn
it to roll-up (towards the deck).
Watch the direction of rotation of the axle: the slat
apron should roll up over and around the axle as
illustrated) and not under and around.
If the axle rotation is inverted with respect to the
direction indicated on the key switch, change the
position of dipswitch 1 on the circuit board (see
below)
28/32
2016/01 - Indice de révision : D - Code : 35101
Programming the ends of travel
Hold the key in position until the slat apron
touches the side opposite the axle. Validate this
as the closed position by pressing .
The LED on the left will flash.
Hold the key in the open position to roll the
cover up around the axle. Validate the pool open
position by pressing .
The LED on the left will go out.
Hold the key in the close position. Hold the key
in this position until the motor stops.
When the 2nd LED starts to flash, switch the
key to the other direction and release it. The
cover rolls up around the axle. The LED goes
out, programming is complete.
Nota bene: The ends of travel settings could be
lost for the following reasons:
ƒ
Power failure while opening or closing the cover
ƒ
Power failure while the cover is partially opened
or closed.
Should this occur, reprogram the ends of travel as
described previously.