Installing The Casings; Programming Ends Of Travel (Version Ec With Ends Of Travel) - Delta EVODECK EC Installation And Maintenance Instructions Manual

5) Installing the casing
„
Holding the casing in both hands, position it over the
top of the stand. Make sure that electrical cables will
not be caught between the flange and the casing.
Swing the casing down into position.
V. PROGRAMMING THE ENDS OF TRAVEL (VERSION EC WITH ENDS OF TRAVEL)
Remove the casing from the motor stand to access
the ends of travel programming panel.
Whether its a first installation or a modification of
the ends of travel, begin with an initialisation:
On the control panel, all the LEDs
are out.
Use the self tapping screws 4.2x13 to fix the casing
to the flange.
Hold the two keys
LEDs begin to flash.
Press OK for 1 second.
The first two LEDs light up.
2016/01 - Indice de révision : D - Code : 35101
in for 5 seconds, all 5
27/32