Preparation Prior To Assembly; Seating The Mechanical Assembly - Delta EVODECK EC Installation And Maintenance Instructions Manual

IV. PREPARATION FOR ASSEMBLY

1) Seating the mechanical assembly

„
Once you have decided which end of the pool the
cover will be installed on, carry out the following
preparations (if necessary) :
ƒ
Trim the coping nose on each side as shown in
the following diagram:
The amount L by which the coping should be
trimmed (as measured from the nose of the coping
on the back wall) will depend on the length of the
slat apron and the radius of the pool corner:
Length of the
slat apron right angle
8 m
9 m
10 m
11 m
12 m
If the coping underneath the proposed site of
the stands is not flat, it may be resurfaced (see
opposite).
22/32
2016/01 - Indice de révision : D - Code : 35101
"L" (in cm)
"L" R15 (in cm)
38
39
40
41
42

"L" R20 (in cm) "L" R225 (in cm) "L" R30 (in cm)
38 43
39 44
40 45
41 46
42 47
Pool width
?
Coping nose
Nez de margelle
Cut
Taille
Pool radius
Rayon de bassin
Resurfacing
Surfaçage
48
49
50
51
52
Zone to be trimmed
Level with the wall

53
54
55
56
57
Zone to be levelled