Motorised Version (Ec): Wiring - Delta EVODECK EC Installation And Maintenance Instructions Manual

4) Motorised version (EC): electrical
„
wiring
The EVODECK EC motor should be wired in
by an experienced professional according to
the diagram below. A 30 mA differential circuit
breaker should be installed at the head of the
line.
Push and then lift the electrical box to release it
from the stand so that you can move it forward to
remove its lid.
Using a flat head screw driver, loosen the 4 screws
in each corner of the lid and remove the lid.
26/32
2016/01 - Indice de révision : D - Code : 35101
Feed the power cable (3G2.5 cable, three 2.5 mm2
wires) through the cable gland, strip the ends of
each wire and connect them to the live and neutral
terminals in the fuse holder.
The earth wire should be connected to the
metal plate using the yellow eyelet lug provided
(premounted on the threaded earth rod). Using a
suitable pliers, crimp the lug onto the copper at the
end of the earth wire, then fasten the eyelet of the
lug to the earth terminal by tightening with the nut.
Close the box, taking care to ensure that no wires
are caught between the box and the lid. Clip the
electrical box back into position on the stand.
Mount the key button on the casing in the hole
provided taking care to align the notch on the button
with the notch in the hole.