S&P UVF ECOWATT Series Manual page 23

6. HANDLING
• The UVF ECOWATT units are supplied packed in a single cardboard box.
• When unit received, unpack and make sure the packaging is intact; any defect may indicate da-
mage to the unit. Review it carefully to make sure that no parts are missing.
• If there is any damage to the unit or the shipment is not complete, write down the problems on
the delivery slip and send a claim to the carrier. Also report any problems to S&P.
• The unit should be handled carefully and only horizontally.
• Manipulate the unit by hand. If using a forklift, place the box on a pallet. Do not manipulate the
box directly with the blades of the forklift.
7. INSTALLATION
7.1. OVERVIEW
• The technician responsible for unit receipt must ensure that the characteristics of the existing
power supply agree with the electrical data on the unit's identifi cation plate.
• Before installing the unit in its fi nal position, make sure that the place where it will be located is
strong enough to support its weight.
• Under no circumstances should these units be installed in fl ammable or explosive environments,
in environments that contain oil vapours, salt air, or corrosive environments.
• Equipment installation can present hazards due to the material used, pressures in the system
and the electrical components. For this reason, only trained and qualifi ed service personnel may
install service or repair the equipment.
• As a precaution, when performing operations inside the equipment, shut off the power at a main
breaker. This serves to prevent any accidents involving the equipment's moving parts, which can
start accidentally, well as to prevent any direct or indirect contact with live parts.
• The unit must also be disconnected by the cut-off switch integrated in the terminal b ox of the
product.
EN
23