S&P UVF ECOWATT Series Manual page 21

1. OVERVIEW
• We appreciate the trust you have placed in us by purchasing this device. You have purchased a
high-quality product that has been manufactured in strict compliance with recognized technical
regulations regarding safety, and in accordance with EC standards.
• Read this instruction booklet carefully, since it contains important information for your safety
during the installation, use and maintenance of this product. Keep this booklet in case you need
to consult it in the future.
• We ask that you make sure the equipment is in perfect condition when you unpack it, since any
existing defect is covered by the S&P warranty.
• Technicians responsible for installing, start-up and maintenance must read the instructions and
be familiar with them before starting work.
2. SAFETY STANDARDS AND "EC" MARKING
• S&P engineers are fi rmly committed to research and development to achieve products with im-
proved effi ciency that complies with current safety standards.
• The standards and recommendations indicated below refl ect current standards in the fi eld of
safety, and therefore are based primarily on meeting standards of a general nature. Consequent-
ly, we recommend that all personnel exposed to risks adhere strictly to local regulations in force
regarding hazard prevention.
• S&P is in no way responsible for any damage or injury caused to persons or objects resulting
from failure to comply with safety standards, and any possible modifi cations to the product. The
EC seal and statement of conformity serve as proof of the product's compliance with applicable
European Community standards.
3. GENERAL STANDARDS
• Product risks have been analysed pursuant to the provisions of the Machinery Directive. This
manual contains information intended for all personnel exposed to hazards, with the goal of
preventing personal injuries or damage to objects resulting from mishandling or improper main-
tenance. All maintenance service work (corrective and preventive) must be performed with the
equipment stopped and disconnected.
• To avoid danger of possible accidental start up ensure that the equipment is electrically isolated
and locked. If this is not possible, warning signs should be placed on main distribution console
that state:
"WARNING: controls disconnected for maintenance"
• Before connecting the power cable to the motors, make sure that the voltage on the line matches
the voltage indicated on the unit's identifi cation plate.
• Check periodically the labels on the product. In case that due to time action them are not legible,
then replace by new ones.
EN
21