Turning The Led On Or Off (Rdr2650/Rdr2680); Turning The Introduction Screen On/Off (Rdr2650/Rdr2680); Accessing General Radio Information (Rdr2650/Rdr2680); Checking The Radio Id (Rdr2650/Rdr2680) - RCA RDR260 Series Instruction Manual

Professional digital two-way radios
Table of Contents

Advertisement

RDR26x0 Series Professional
Digital Two-Way Radios
Communications Systems
Turning the LED Indicator On or Off (RDR2650/RDR2680)
You can enable and disable the LED Indicator if needed.
1. Press [
] to access the menu.
2. Press [
or
] to navigate to Utilities and press [
3. Press [
or
] to navigate to Radio Settings and press [
select.
4. Press [
or
] to navigate to LED Indicator and press [
button.
5. If the display shows Turn On. Press [
and the display shows All LEDs On. If the display shows Turn Off
press [
] to disable the LED Indicator and the display shows All
LEDs Off.
Note: The display backlight, buttons and keypad backlight are
automatically turned off if the LED indicator is disabled.
Turning the Introduction Screen On or Off (RDR2650/RDR2680)
You can enable and disable the Introduction Screen if needed.
1. Press [
] to access the menu.
2. Press [
or
] to navigate to Utilities and press [
3. Press [
or
] to navigate to Radio Settings and press [
select.
4. Press [
or
] to navigate to Intro Screen and press [
select.
5. If
The
display
to enable the Introduction Screen and the display shows Intro
Screen On. If the display shows Turn Off press [
Introduction Screen and the display shows Intro Screen Off.

Accessing General Radio Information (RDR2650/RDR2680)

Your radio contains information on the following:
• Radio ID
• Software version
• Codeplug Version
Note: Press [
] at any time to return to the previous screen.

Checking the Radio ID (RDR2650/RDR2680)

1. Press [
] to access the menu.
2. Press [
or
] to navigate to Utilities and press [
3. Press [
or
] to navigate to Radio Info and press [
4. Press [
or
] to navigate to My Number and press [
5. The display shows radio ID and alias.

TROUBLESHOOTING

Symptom
Radio will not power on
The operating time is noticeably shorter
than normal even though the battery is
properly charged.
Cannot talk to or hear transmissions from
your group members
Radio is on, but you cannot hear voice trans-
missions or they are not very loud
] to enable the LED Indicator
shows
Turn
On
press
] to disable the
Solution
a. The battery needs charging. Recharge the battery or replace it with a fresh one.
b. The battery is not properly installed. Remove the battery and reattach it.
The battery has worn out; it is time to buy a new battery.
a.
The battery is not fully charged. Make sure that the battery is removed after LED
b.
indicator has turned green.
a. Make sure that your radio operates on the same channel and / or has the same
CTCSS/CDCSS settings as your group members.
b. Make sure you are within their communication range.
a. Turn the volume control knob to its maximum volume.
b. Return the radio to your dealer to check for microphone damage.
Copyright © 2020 RCA Communications Systems www.RCACommunicationsSystems.com

Checking the Firmware Version (RDR2650/RDR2680)

Display the firmware version on your radio.
1. Press [
] to select.
2. Press [
] to
3. Press [
4. Press [
]
button.
5. The display shows the current Firmware version.

Checking the Codeplug Version (RDR2650/RDR2680)

Display the codeplug version on your radio.
1. Press [
2. Press [
3. Press [
4. Press [
5. The display shows the current Codeplug version.
] to select.

CARE AND CLEANING

] to
Do not directly handle the radio by its antenna or external
microphone.
] to
Do not place the radio in a dusty or dirty environment.
[
]
Clean the radio with a lint-free cloth moistened with clean water
and/or a mild dishwashing liquid to remove dirt, grease and dust.
Avoid subjecting the radio to corrosives, solvent or spirits.
For Sales, Warranty and Customer Support please contact:
Discount Two-Way Radio Corporation – Worldwide Distributor
] to select.
] to select.
] button.
INSTRUCTION MANUAL
] to access the menu.
or
] to navigate to Utilities and press [
or
] to navigate to Radio Info and press [
or
] to navigate to Firmware Ver. and press [
] to access the menu.
or
] to navigate to Utilities and press [
or
] to navigate to Radio Info and press [
or
] to navigate to CP Ver. and press [
555 W. Victoria Street
Rancho Dominguez, CA 90220
Phone: 310-224-5100 / Fax: 310-224-5101
www.discounttwo-wayradio.com
14
] to select.
] to select.
]
] to select.
] to select.
] button.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Rdr2620Rdr2650Rdr2680

Table of Contents