Advertisement
3.4 Fujitsu Test Pin (JP210)
This pin is usable for internal tests if the chip is in the test mode. In run mode this jumper must be put on
GND.
Test
3.5 Reset Pin (JP212)
The Jumper JP212 determines the Lavender Reset Pin.
It can be connected directly with the Reset of the VGC, or with a port of the MCU, to execute a software
Reset.
Reset
3.6 Video Input Processor (JP308, JP302, JP301, JP305, JP306, JP307)
Power supply
voltage
VIC enable
2
I
C-Bus slave
address select
Video Scaler
Vertical Reference
JP210
1-2
2-3
JP212
1-2
2-3
JP308
On (closed)
supply voltage for VIC
OFF (open)
JP302
1-2
2-3
JP301
GND (closed)
VCC (open)
JP305
1-2
2-3
Description
Test mode
Run mode
Description
Software Reset
VGC Reset
Description
Digital and analog
NO power supply
Description
Chip enable connected
with VCC
Chip enable connected
with PortS0-MCU
Description
0 = 48h for write,
49h for read
1 = 4Ah for write,
4Bh for read
Description
HS connected with
VREF (GDC)
VS connected with
VREF (GDC)
7
Advertisement
