BT OMEGA Owner's Manual page 9

name plate facing up.
• Remove the seven receiver screws.
• Lift name plate receiver away from other receiver half (Fig. 1.7).
N N o o t t e e : : The stock will be under some spring tension and may spring out
when the top name plate receiver is lifted off.
• Remove the bumper O-ring.
• Remove spring and spring
guide.
Removing Rear Bolt,
Cocking Handle, and
Linkage Arm
(Fig. 1.9)
• Rotate rear bolt counter-
clockwise.
• Remove linkage arm.
• Remove bolt handle.
• Slide the rear bolt rear-
ward and remove.
Trigger Assembly
The trigger assembly lifts
out as a single unit. It is rec-
ommended that you do not
take it apart (Fig. 1.8).
Removing Stock,
Spring Guide, Bumper
and Spring
(Fig. 1 .8)
• Lift the stock out of the
Fig. 1.8
right-side receiver.
Fig. 1.9
B T P A I N T B A L L . C O M
Removing Barrel Adapter, Ball detent and Front Bolt
(Fig. 1. 1 0)
• Lift away barrel adapter (and barrel if still installed).
• Lift out ball detent;
notice its position before
removing it.
• Slide the Front Bolt
forward and off the
power tube
Reassembly
To reassemble the mark-
er, reverse the disassem-
bly instructions starting
with the barrel adapter,
ball detent, and front bolt
removal. While reassem-
bling the marker, you
should lightly oil all O-rings and sliding parts. All parts and O-rings
returned to the marker should be free of debris and visual nicks and
scratches which can alter the performance of the marker. All screws
returned to the marker must be tightened so there is no chance of them
vibrating loose.
Fig. 1. 1 0
7