Firing Your Marker; Velocity Adjustment; Unloading Your Marker - BT OMEGA Owner's Manual

Stock Adjustment
Push the stock adjustment lever
up and adjust the stocks length
by pulling or pushing on the
back of the stock (Fig. 1.5).

4. Firing Your Marker

W W a a r r n n i i n n g g : : Always keep your
marker pointed in a safe direc-
tion! Everyone within firing
range should always use paint-
ball-approved eye and face protection in the presence of live paintball
markers. Make sure the marker is set to "Safe Mode", before following the
steps below.
• Place the empty loader onto the marker.
• Be sure that it is securely mounted in place.
• Cock the marker.
• Apply the air cylinder, pressurizing the marker.
• Put the paintballs into the loader.
• Remove the barrel plug, sock, or barrel-blocking device.
• Aim the BT marker in a safe direction.
• Set the safety to the "Fire" position.
• Aim the marker at the target.
• Place your finger on the trigger.
• Pull the trigger with a smooth squeezing motion.

5. Velocity Adjustment

Always check the velocity of the marker prior to playing paintball.
Different playing fields may have different maximum velocity limits. At no
time should you shoot at velocities above 300 feet-per-second (fps).
• Put on an eye protective device designed specifically for paintball and
4
make sure that anyone within range of the BT marker does the same.
• While pointing the marker in a safe direction, remove the barrel-block-
ing device.
• Point the BT marker over a chronograph that will measure the veloc-
ity of the paintballs discharged by the marker.
• Set the marker to
"Fire Mode" (turn
safety off).
• Pull the trigger
and check the
reading on the
Fig. 1.5 chronograph.
• Locate the velocity
adjuster screw on
the left side of the
marker.
• Using a 5/32" Allen wrench, turn the screw inward or clockwise to
reduce the velocity, and outward or counterclockwise to increase the
velocity of the paintballs discharged from the marker (Fig. 1.6).
D D O O N N O O T T R R E E M M O O V V E E T T H H E E V V E E L L O O C C I I T T Y Y A A D D J J U U S S T T M M E E N N T T S S C C R R E E W W . .

6. Unloading Your Marker

• Put on an eye protective device designed specifically for paintball and
make sure that anyone within range of the BT marker does the same.
• Make sure the barrel-blocking device is properly installed and the
marker is set to "Safe Mode".
• Loosen the loader clamping screw with a 3/16" Allen wrench.
• While holding the paintball hopper in place, invert the marker so that
the hopper is below the BT marker.
• Remove the loader and all paintballs.
• While pointing the BT marker in a safe direction, remove the barrel-
blocking device.
B T P A I N T B A L L . C O M
Fig. 1.6