Table of Contents
Advertisement
WALL CONTROL INSTALLATION
MAGIQTOUCH CONTROLLER
Refer to Installation Manual MagIQtouch Controller, Item 1D
included in Installation Components.
CONTROL SYSTEM
Climate Wizard coolers are supplied from the factory with
a MagIQcool Wall Control, a MS1 BMS Control and a 20m
(65') control cable. This makes it possible for the cooler to be
controlled independently and automatically from the zone to
which it is delivering cool air.
The MagIQcool Wall Control incorporates a thermostat that
regulates fan speed to try and maintain indoor temperature
within ±1°C (± 3°F) of the set temperature.
LOCATING THE WALL CONTROL
Locating the Wall Control
The Wall Control should be placed approximately 1.5 metres
above the floor, in the most used room in the home. This will
give the optimum temperature sensing and operating position
for the user.
Placement is critical for correct functioning of the thermostat
(incorporated in the Wall Control). The following points must be
taken into consideration:
• Avoid direct sunlight exposure.
• Avoid mounting on external walls.
• Avoid mounting the wall control near heat sources such as
stoves and televisions.
• Do not locate in the direct airflow of the duct outlets.
• Do not locate in strong drafts or in dead spots such as
cupboards/drawers.
• Always fill in the cable entry hole. Hot air coming through the
wall may interfere with the temperature measurement.
CAUTION: Make sure there are no
!
electrical cables, gas or water pipes (or
similar), behind where you intend to drill.
Running the Control Cable to the Wall Control
Using the loop on the end, draw the cable through the wall
cavity to the hole made at the wall bracket. Carefully remove
the tape from the cable loops and check that the plug has not
been damaged. Connect the cable to the wall control and mount
the wall control onto its bracket.
Important! Take care not to damage the cable or plug during
this process. Always seal the cable entry hole.
22 |
MOUNTING THE MAGIQTOUCH CONTROLLER
Remove the mounting bracket from the rear of the MagIQtouch
Controller.
Step 1
ILL1582-C
Step 2
Step 3
ILL1584-A
ILL1585-A
ILL1586-A
Advertisement
Table of Contents
