Replacing The Toner Cartridge (Tn-550/Tn-580) - Brother DCP-8065DN User Manual

Multifunction center/facsimile machine
Hide thumbs Also See for DCP-8065DN:
Table of Contents

Advertisement

d
When you find the substance on the
drum surface that matches the print
sample, gently dab the surface of the
OPC drum with a cotton swab that is
lightly dampened with isopropyl alcohol.
CAUTION
The OPC drum is photosensitive so do not
touch it with your fingers.
Do not use a scrubbing or wiping motion
because this might damage the drum.
DO NOT clean the surface of the OPC
drum with a sharp object, such as a ball-
point pen, because this might cause
permanent damage to the drum unit.
Troubleshooting and routine maintenance
Replacing the toner cartridge
(TN-550/TN-580)
The TN-580 toner cartridge can print
approximately 7,000 pages using a high yield
toner cartridge. When the toner cartridge is
running low, the LCD shows Toner Low.
The machine is supplied with a standard
TN-550 toner cartridge that must be replaced
after approximately 3,500 pages. Actual page
count will vary depending on your average
type of document (i.e., standard letter,
detailed graphics).
Note
It is a good idea to keep a new toner
cartridge ready for use when you see the
Toner Low warning.
Discard the used toner cartridge according to
local regulations, keeping it separate from
domestic waste. Be sure to seal up the toner
cartridge tightly so that toner powder does not
spill out of the cartridge. If you have
questions, call your local waste disposal
office.
We recommend that you clean the machine
and corona wire of the drum unit when you
replace the toner cartridge. (See Cleaning the
laser scanner window on page 70 and
Cleaning the corona wire on page 71.)
C
73

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dcp-8060

Table of Contents