Tray Select; Out Of Memory Message - Brother DCP-8065DN User Manual

Chapter 5

Tray Select

You can change the tray use only for the next
copy.
a
Load your document.
b
Use the dial pad to enter the number of
copies (up to 99).
c
Press Tray Select.
nnonn+
Contrast:-
Quality :Auto
Enlg/Red:100%
Tray :MP>T1
Select d c & OK
d
Press d or c to select the tray usage.
Press OK.
e
Press Start.
Press Tray Select
* XXX is the paper size you set in Menu, 1, 2.
Note
• T2 and Tray #2 appear only if the optional
paper tray is installed.
• To change the Tray select setting,
see Tray use in Copy mode on page 18.
34
5
c
MP>T1 or M>T1>T2
T1>MP or T1>T2>M
#1(XXX)*
#2(XXX)*
MP(XXX)*
Out of Memory
message
If the memory becomes full while you are
making copies, the LCD message will guide
you through the next step.
If you get an Out of Memory message while
scanning a subsequent page, you will have
the option to press Start to copy the pages
scanned so far, or to press Stop/Exit to
cancel the operation.
If you run out of memory, you can add it. See
Memory Board on page 49.
5