Test 2 Bb Flash Phone - Nokia RH-17 Series Troubleshooting - Rf

RH-17
Troubleshooting — RF
VCORE - 1.50V @ C403
VIO - 1.8V @ C242
VANA - 2.8V @ C264
VFLASH1 - 2.8V @ C239
VR3 - 2.8V @ C256
• Check logic signals and clocks:
Power_OnX @ R301
UEMint - 2.80 Vdc @ test point J405
PURX - 2.80 Vdc @ test point J402
SleepX - 1.80 Vdc @ test point J403
Clk 19M2_UPP-19.2MHz @ C524
SleepClk - 32.768kHz @ J404

Test 2 BB Flash Phone

Description
The purpose of this test is to verify that the phone software was downloaded at panel
flash. If download was not successful, phone will try and flash for a second time.
Explanation of Result
Pass or Fail
Manual Verification
Manual flashing using Prommer Box and Phoenix at bench.
1 Make sure correct connection is configured at FPS-8. First, set up FPS-8 with
serial (AXS-4) and parallel cables. Next, power up box with 6-volt supply and
place communication cable XCS-4 between FPS-8 and Flash Adapter (FLA-44),
FLAL Fixture MJS-82, or JBV-1 (with adapter MJF-28).
2 Make sure that Phoenix's connection is correct. In Phoenix, select File>Manage
Connections>Add>Mode to manual>Media to FBUS>Port NUM 1 or 2 (this is
dependent on Local PC com port selection)>Bit Rate to
115200>COMBOXDEF_MEDIA to FBUS; then Apply.
3 Check that Prommer Box FPS-8 is correctly configured. In Phoenix, go to Flash-
ing>FPS-8/FPS-8C Maintenance. Make sure current version is A2.10.
Page 14
Nokia Corporation
CCS Technical Documentation
Confidential Issue 1 04/2003