Honda Interceptor 2014 Owner's Manual page 109

9. Install the left brake caliper and tighten
new mounting bolts.
Torque: 33 lbf·ft (45 N·m, 4.6 kgf·m).
Take care to prevent the brake caliper
u
from scratching the wheel during
installation.
Use new mounting bolts when
u
installing the brake caliper.
NOTICE
When installing the brake calipers into position on
the fork legs, carefully fit the brake disc between
the pads to avoid scratching them.
Tire Puncture
10. Lower the front wheel on the ground.
11. Apply the brake lever several times.
Then, pump the fork several times.
12. Retighten the left axle pinch bolt.
Torque: 16 lbf·ft (22 N·m, 2.2 kgf·m).
13. Raise the front wheel off the ground
again, and check that the wheel rotates
freely after you release the brake.
14.
INTERCEPTOR DELUXE only
Install the wheel speed sensor and
tighten the bolts, then check the
clearance between the wheel speed
sensor and the pulser ring.
15. Remove the protective tape or cloth.
If a torque wrench was not used for
installation, see your dealer as soon as
possible to verify proper assembly.
Improper assembly may lead to loss of
braking capacity.
u Removing Wheels
continued 107