Brother DCP 8045D User Manual page 22

LED DCP status
Service error
Red
Cover open
Toner empty
Paper error
Red
Scan lock
Others
Out of memory
Description
Follow the steps below.
1. Turn off the power switch.
2. Wait a few seconds, and then turn it back on
and try to print again.
If you cannot clear the error and see the same
service call indication after turning the DCP
back on, call your dealer or Brother authorized
service center.
The cover is open. Close the cover. (See Error
messages on page 14-1.)
Replace the toner cartridge with a new one.
(See Replacing the toner cartridge on page
14-24.)
Put paper in the tray or clear the paper jam.
Check the LCD message. (See Troubleshooting
and routine maintenance on page 14-1.)
Check that the scanner lock lever is released.
(See Scanner Lock Lever on page 1-5.)
Check the LCD message. (See Troubleshooting
and routine maintenance on page 14-1.)
Memory is full. (See Error messages on page
14-1.)
INTRODUCTION 1 - 9